Cummins Crankshaft Barring Tool Fits all Stock 5.9L and 6.7L Stock Dampers and Fluidamprs Fleece Performance

Cummins Crankshaft Barring Tool Fits all Stock 5.9L and 6.7L Stock Dampers and Fluidamprs Fleece Performance

Manufacturer part number: FPE-CCBT

Cummins Crankshaft Barring Tool. Turn over your Cummins with ease with this Cummins Crankshaft Barring Tool. It is much easier to use than the barring tool that interfaces the flywheel housing and starter ring gear.

Remove the 4 bolts holding on the damper, install this tool, reinstall the bolts, and torque to spec. You'll never back a bolt out of the damper when trying to reach TDC and overshoot.

They are especially useful when removing and reinstalling a transmission. No need to use a pry bar on the starter ring gear to rotate the engine to remove and replace converter bolts.

Features:

• Accepts 1/2 inch drive ratchet
• Designed to be used with factory crank bolts and roll pins
• No need to remove after installed
• Built from 1018 steel
• Works with Vibratech Fluidampr as well as factory dampers

Supplier-specified finish: yellow zinc plating for corrosion resistance.

Technical Specifications

• Engine family: Cummins
• Application years: 1994-2002, 2003-2010, 2011-2018
• Engine displacement: 5.9 Liter, 6.7 Liter
• Fuel type: Diesel
• Sold as: Each
• Country of origin: USA
• UPC: 635909310990

Application and Ordering Notes

Match the application, engine, transmission and any cab, bed, tank or kit requirements stated above before ordering. A vehicle-generation category is a browsing aid and does not override product-specific fitment restrictions.

California Proposition 65 Warning

CALIFORNIA WARNING: Cancer and Reproductive Harm -www.P65Warnings.ca.gov